The simplicity and complexity of our kitchen countertops are closely related to our current popular decoration style. Now the more popular decoration style is modern simple light luxury style, so the kitchen countertops of this style are relatively simple. Let's talk about it in detail.
First, let's talk about the position of the front hanging edge of the table top. There are generally two methods for this position.
The first method is to directly turn the angle of 45 degrees, and the second method is to make a small arc surface at the position near the outer edge on the basis of 45mm lifting.
The second method is mainly to prevent the water on the table from falling down on the ground or the floor cabinet along the table. However, the style of the first way will be more.
Next, let's talk about the position of retaining water against the wall. There are generally two methods for this position.
The water retaining of the first mode is installed after the installation of the table top, and the requirements for the size of the table top are not very high;
The second method is to make an arc transition surface between the water retaining wall and the countertop. This method requires the water retaining wall and the countertop to be combined in the factory. Therefore, the requirements for the single processing and installation of the on-site measuring ruler are relatively high. Moreover, the gap between the water retaining wall and the wall will be significantly different due to the uneven wall tiles, resulting in the beautiful joints made in the later period. Therefore, there are many water retaining strips using the first method.
Finally,Then let's talk about the location of the sink. There are generally three methods for this position. Defined by the relationship between the sink and the countertop.
First, the sink is covered on the table, which is what we generally call the basin on the table. In this way, the outer edge of the sink is higher than the table top, so that there is a very obvious gap between the table top and the sink side. This position is also a relatively prominent position where dirt is hidden, and it is not easy for the water from the table top to flow to the sink.
Second, the sink is basically flush with the countertop or the sink is about 1-2mm lower than the countertop, which is what we generally call the Taichung basin. In this way, the gap between the sink and the table top is left on the plane. If a beautiful seam is made, it will be much better than the first one in the later stage, and the water or dirt on the table top can be easily cleaned into the sink.
Third, the sink is bonded under the table panel, which is what we generally call the basin under the table. In this way, the gap is left under the table panel, which is more convenient for the cleaning and beauty of the table. Therefore, mode 2 and mode 3 are commonly used.
Quartz stone kitchen countertops are basically the practice of this key position. Hope you all find a way to decorate your kitchen.
